High Temperature Roof Exhaust FansWill Bush
High Temperature Roof Exhaust Fans. Steel Mills, Textiles, Foundries, Forging, Annealing and Heat Treating use Roof Exhaust Fans. Due to high temperature processes. Excess heat must be removed. Heat rises to roof level. Removing excess heat from roof level is most effective. Carl J. Bush Company – USA specializes in the manufacture of Roof Exhaust Fans. High Temperature construction.
Hence, call them at (248) 276-8400.
CJB High Temperature Roof Exhaust Fans. Temperatures to 375 Deg. F.
Also referred to as “DYE-VAT” High Temperature Construction. Fans were developed for High Temperature, High Moisture and Steam conditions in the Rug-Dying textile industry. Also used to vent heat over industrial ovens.
Sizes 18″ to 60″
High moisture. Contaminated airstreams. Therefore motor/drive components located outside the airstream.
Pillow Block Bearings.
High Temperature Construction available (to 375 Deg. F.)
Explosion Prof Construction available
Can be adapted to facilitate ductwork connection to fan inlet.
FEATURES AND BENEFITS OF HIGH TEMPERATURE ROOF EXHASUT FANS
Especially relevant Model BCS tube axial duct fans utilize cast aluminum spark-resistant propeller standard. Also heavy gauge curb cap continuously welded to prevent water penetration. Hence butterfly damper section mill galvanized construction. Also damper blades open when fan is energized. And close watertight when off. Consequently dampers rotate in nylon bearings. On stainless steel axle. Also butterfly damper section removable. Easy propeller access. In addition combination weather cover/belt guard. Hence motor/drive components located outside airstream. High temperature. Maximum 375°F. Hence fabricated steel propeller.
- Available in 304 or 316 stainless steel construction.
- Weatherproof non-fused disconnect switches.
- Insulated roof curbs for flat or pitched roofs.
Finally, for additional information or to consult with Carl J. Bush Company – USA, please click on the below link to their website.